Cabin Patch Crochet Bookmark Free Pattern

Introduction

The Cabin Patch Crochet Bookmark is a cozy little project made for anyone who loves a handmade touch in their reading life. It is perfect for total beginners, for gift makers, and for anyone who wants a quick, satisfying finish in under an hour. Worked in bulky wool, the flat rectangle has a soft, squishy feel and a lovely ridged texture from the back-loop half double crochet. Forest green with a rust border and a simple yarn tassel gives it a warm, cabin-inspired look that feels like a little patch of the woods tucked between the pages.

Materials Needed

• Yarn: Bulky weight (category 5) wool yarn — approximately 20 yards forest green (color A) and 5 yards rust (color B).
• Hook: 6.0 mm (J-10) crochet hook.
• Notions: Tapestry needle for weaving in ends, scissors, and a ruler or tape measure for checking gauge.
• Finished size: Approximately 2 inches (5 cm) wide by 7 inches (18 cm) long, including the tassel.

Abbreviations

• ch — chain: make a loop of yarn and pull it through the loop on your hook.
• hdc — half double crochet: yarn over, insert hook into stitch, pull up a loop, yarn over, pull through all three loops on the hook.
• sc — single crochet: insert hook into stitch, pull up a loop, yarn over, pull through both loops on the hook.
• sl st — slip stitch: insert hook into stitch, yarn over, pull through both the stitch and the loop on your hook at once.
• st(s) — stitch(es).
• back loop only — work into the loop of the stitch that is farthest from you, leaving the front loop unused.

Gauge

12 hdc x 10 rows = 4 inches (10 cm) in back-loop hdc. To check, crochet a small swatch in back-loop hdc and measure the middle of it with a ruler; if your stitches are bigger or smaller, change hook size until the gauge matches.

Tips Before You Start

• Keep your turning chain loose so the long edges of the bookmark stay straight and don't pucker.
• Work the border stitches evenly — aim for roughly one sc per row along the sides and one sc per stitch along the top and bottom edges — so the rectangle stays flat.
• Use a slightly larger hook for the border round if your edge tends to curl, then switch back for the main body.
• Cut the tassel strands a little longer than 6 inches so you have room to trim them evenly at the end.

Step-by-Step Instructions

Square (Color A)

Row 1: Ch 7, hdc in the 2nd ch from hook and in each ch across (6 hdc).

Row 2: Ch 1, turn, hdc in the back loop only of each st across (6 hdc).

Rows 3–10: Repeat Row 2 (6 hdc). Do not fasten off.

Border (Color B)

Border round: Ch 1, turn, work 1 sc evenly around the entire square (approximately 32 sc), join with a sl st to the first sc. Fasten off.

Tassel (Color B)

Tassel: Cut 6 strands of color B, each 6 inches long. Fold the bundle in half, insert the hook through one corner of the square, pull the folded loop through, then pull the loose ends through that loop and tighten. Trim the ends evenly.

Assembly and Finishing

There is no seaming needed for this project — the bookmark is worked as one flat piece. Weave in all yarn ends on the wrong side with the tapestry needle, tucking them into the border stitches so they don't show. Lightly block the bookmark by misting it with water and pinning it flat to dry; this helps the rectangle lie straight and the border sit evenly. Give the tassel a final trim once the piece is dry.

Pro Tips and Variations

• Swap the forest green and rust for any two colors you love — a cream body with a deep red border looks just as cabin-cozy.
• Make a set of three bookmarks in different color pairs for a quick handmade gift bundle.
• For a slightly stiffer bookmark that holds its shape in a book, try a cotton-blend bulky yarn instead of pure wool.