Spiral Fairy Bunting Free Crochet Pattern

Introduction

This Spiral Fairy Bunting is a sweet, beginner-friendly project that turns a few scraps of worsted yarn into a whimsical garland of pastel circles. Each flat spiral disc is worked in continuous rounds of single crochet, then topped with a tiny mint leaf so the circles look like little fairy wings fluttering along a chain. The finished bunting is soft, light, and slightly textured, with a gentle drape that hangs beautifully across a nursery wall, party table, or reading nook. If you can make a magic ring and a single crochet, you can make this whole banner in an afternoon.

Materials Needed

• Yarn: Worsted weight (4) acrylic yarn in lavender (A), mint (B), and butter yellow (C), approximately 30 yards each.
• Hook: 5 mm (H-8) crochet hook.
• Notions: Tapestry needle, scissors, stitch marker (optional, for the spiral start), rust-proof pins for assembly.
• Finished size: Each circle is 3 inches (7.5 cm) in diameter; the bunting is 36 inches (90 cm) long with 5 circles spaced 6 inches (15 cm) apart.

Abbreviations

• ch – chain: yarn over and pull through the loop on your hook.
• sc – single crochet: insert hook, yarn over, pull up a loop, yarn over, pull through both loops.
• hdc – half double crochet: yarn over, insert hook, pull up a loop, yarn over, pull through all three loops.
• dc – double crochet: yarn over, insert hook, pull up a loop, yarn over, pull through two loops, yarn over, pull through remaining two loops.
• MR – magic ring: an adjustable loop you work stitches into, then pull closed.
• sl st – slip stitch: insert hook, yarn over, pull through both the stitch and the loop on your hook.
• st(s) – stitch(es).
• [ ] – repeat the instructions inside the brackets the number of times stated.

Gauge

The first 3 rounds of the spiral circle should measure 1.5 inches (4 cm) in diameter. Work those three rounds, lay the piece flat, and measure straight across the center; if it is larger, go down a hook size, and if smaller, go up.

Tips Before You Start

• Place a stitch marker in the first stitch of each spiral round. Because you do not join between rounds, the marker is the only way to keep your increases in the right place.
• Keep your tension even rather than tight — loose, flat spirals lie nicer against the chain than cupped ones.
• Work all five leaves in mint (B) even on the lavender and yellow circles; the matching leaves are what tie the bunting together.
• Leave the 6-inch tails on the leaves and the 6-inch tails at each end of the chain — you will use them for sewing and hanging.

Step-by-Step Instructions

String (make 1, with A)

Row 1: Ch 100, leaving a 6-inch tail at each end (100 chs). Fasten off.

Spiral Circle (make 5: 2 in A, 2 in B, 1 in C)

Work in a continuous spiral; do not join between rounds.

Rnd 1: MR, 6 sc into the ring (6 sts).

Rnd 2: 2 sc in each st around (12 sts).

Rnd 3: [sc in next st, 2 sc in next st] around (18 sts).

Rnd 4: [sc in next 2 sts, 2 sc in next st] around (24 sts).

Rnd 5: [sc in next 3 sts, 2 sc in next st] around (30 sts).

Rnd 6: Sl st in next st to join. Fasten off and weave in ends.

Leaf (make 5, one per circle, with B)

Row 1: Ch 6, sc in 2nd ch from hook, hdc in next ch, dc in next ch, hdc in next ch, sc in last ch (5 sts). Do not turn.

Row 2: Working along the opposite side of the foundation ch, sc in first ch, hdc in next ch, dc in next ch, hdc in next ch, sc in last ch (5 sts). Sl st to first sc. Fasten off, leaving a 6-inch tail for sewing.

Assembly and Finishing

Thread the 6-inch tail of one leaf onto your tapestry needle and sew it to the outer edge of one circle, one leaf per circle, using the photo as a guide. Repeat for all five circles. Lay the chain string flat and pin the circles along it, leaving 6 inches of bare chain at each end and 6 inches between circles. With matching yarn and the tapestry needle, sew each circle to the chain at its top edge, taking a few small stitches so the circle hangs straight. Weave in all remaining ends. Block lightly by misting the circles with water, pinning them flat, and letting them dry completely so the spirals lie smooth.

Pro Tips and Variations

• Swap the pastels for a single color family, or use up scrap worsted yarn for a scrappy, colorful version.
• Make a longer banner by chaining 150 and adding two more circles, keeping the 6-inch spacing.
• Sew a small bead or a French knot at the center of each circle for a little extra fairy sparkle.